Our New Board
http://ilaselmar.tforums.ws/

the same; door lock installation should
http://ilaselmar.tforums.ws/viewtopic.php?f=2&t=1956
Page 1 of 1

Author:  qizhenapp [ 13 Sep 2017, 16:08 ]
Post subject:  the same; door lock installation should

<p>mm. 2, the door set after the three-dimensional horizontal, vertical tolerance tolerance of +2 mm, horizontal flatness tolerance allowed +1 mm; door sets and the combination of the wall should be fixed screws or gas nails (every meter a lot In 3); between the door and the wall gap with double-sided adhesive styrofoam, styrofoam should be coated evenly, dry after cutting smooth. Second, the line installation line installation should be uniform coating and door sets, wall </p>
<p>fixed, sets of line interface should be flat, tight, after installation side of the same line in a plane; due to wall is not flat, must ensure that line interface smooth. Sleeve tolerance allows tolerance of 1 mm. Third, the door installation 1, the door after the installation, should be flat, vertical, door and the door out of the flat face; door open no abnormal sound, flexible switch. 2, between the door and the gap between the door, the next seam is 6-8 mm, the remaining three </p>
<p>sides of 2.5 mm; all the allowable tolerance of +1 mm gap. 3, the door closed with a tight seal after the seal, do not swing. 4, hardware 1, door hinge should be vertical, flat; flat hinge should be in the door, the door corresponding to the slot, slot should be standardized, the same size and hinge, three allowable tolerance +0.5, after the formation of seamless , Hinge open should be flexible. The three-sided hinge is mounted in a mold and the plug should be inserted in </p>
<p>sliding gate door openers for wood fences in md<br />
water resistant outdoor floor materials<br />
pvc railing ireland</p>

Page 1 of 1 All times are UTC + 3 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/